Mitsubishi Heavy Industries SRK Series Specifications download pdf (Page 16)

4.4 Custom cord switching procedure

If two wireless remote controls are installed in one room, in order to prevent wrong operation due to

mixed signals, please modify the printed circuit board in the indoor unit’s control box and the remote

control using the following procedure. Be sure to modify both boards. If only one board is modified,

receiving (and operation) cannot be done.

(1) Modifying the indoor unit’s printed circuit board

Take out the printed circuit board from the control box and cut off jumper wire (J6) using wire cutters.

After cutting of the jumper wire, take measures to prevent contact with the other the lead wires, etc.

(2) Modifying the wireless remote control

1) Remove the battery.

2) Cut the jumper wire shown in the figure at right.

Slant forward

blowing

HEAT

4.5 Flap and louver control

Control the flap and louver by AIRFLOW





(UP/DOWN) and



(LEFT/RIGHT) button on the wireless remote control.

(1) Swing flap

Flap moves in upward and downward directions continuously.

(2) Swing louver

Louver moves in left and right directions continuously.

(3) When not operating

The flap returns to the position of air flow directly below, when operation has stopped.

(4) Memory flap (Flap or Louver stopped)

When you press the AIRFLOW (UP/DOWN or LEFT/RIGHT) button once while the flap or louver is operating, it stops swinging

at an angle. Since this angle is memorized in the microcomputer, the flap or louver will automatically be set at this angle when the

next operation is started.

¡ Recommendable stopping angle of the flap

Horizontal

blowing

COOL•DRY

Cut

(2) Sleep timer operation

Pressing the SLEEP button causes the temperature to be controlled as shown in the following chart with respect to the set temperature.

4.6 Timer operation

(1) Comfortable timer setting (ON timer)

(3) OFF timer operation

The Off timer can be set at a specific time (in 10-minute units) within a 24-hour period.

If the timer is set at ON when the operation select switch is set at the cooling or heating, or the cooling or heating in auto mode

operation is selected, the comfortable timer starts and determines the starting time of next operation based on the initial value of 15

minutes and the relationship between the room temperature at the setting time (temperature of room temperature sensor) and the

setting temperature.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Comments to this Manuals

No comments

Mitsubishi Heavy Industries SRK Series Specifications Page 16

Comments to this Manuals

Related products and manuals for Split-system air conditioners Mitsubishi Heavy Industries SRK Series